Chain drive is fitted to the vast majority of sports bikes, roadsters and adventure bikes. It is also one of the most exposed parts: dust, water and road grime all take their toll. A well-kept chain means more safety, less noise, better fuel economy and, above all, a far longer service life. Here are the right habits.

Why chain maintenance is crucial

A dry or slack chain wears out early, can jump off the sprocket and, in the worst case, lock the rear wheel. Too tight, on the other hand, and it overloads the bearings and the output shaft seal. The correct setting is a balance, and it is specific to each model.

How often should you lube and check?

  • Lubrication: every 300 to 500 miles (500 to 800 km), and always after riding in the rain or cleaning the chain.
  • Tension check: roughly every 600 miles (1,000 km), or as soon as you feel a tight spot.
  • Deep clean: depending on use, every 1,200 to 1,900 miles.

These intervals vary with your riding style and the weather. Cylabike offers tailored presets and combines reminders based on both distance and time.

Lubricating your chain, step by step

  1. Put the bike on a paddock stand so the rear wheel spins freely.
  2. Spray on a suitable cleaner and brush all of the links.
  3. Let it dry, then apply the lube to the inner face of the chain, where centrifugal force will spread it.
  4. Turn the wheel slowly to cover the whole length.
  5. Let it soak in for a few minutes before riding to avoid fling-off.

Use a motorcycle-specific lube (and one that is O-ring safe if your chain has seals). Avoid products that are too thin, as they trap dust.

Setting the tension correctly

Always work to the slack figure specified by the manufacturer (often between 25 and 40 mm, measured at the tightest point). Loosen the wheel spindle, adjust the tensioners evenly left and right, check the alignment against the markings, then torque everything back up. A poorly set tension shows up straight away under acceleration.

When to replace the chain and sprocket kit?

The "chain kit" is the chain, the front sprocket and the rear sprocket. You change them together, because a new part on worn parts wears out quickly. Service life is around 15,000 to 19,000 miles (25,000 to 30,000 km), but it varies hugely with maintenance. Wear signs to watch for:

  • A chain that needs adjusting more and more often, or that has tight spots.
  • Hooked or pointed teeth on the rear sprocket.
  • Being able to lift the chain several millimetres away from the back of the rear sprocket.
Log every lube and every adjustment in Cylabike: the full history helps you anticipate the kit replacement and understand your real cost per mile.

Track your bike's maintenance in one tap

Chain, fork, brakes, front and rear tyres: Cylabike reminds you of every service at the right time.

Discover Cylabike